Hi
Does anyonee know the total resistance of the pots use in the gimbals of the Turnigy 9XR transmitter ?
Also are there any dimnesional drawing of the gimbal that I can get from somewhere?
9xr gimbal resistance ???
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 9xr gimbal resistance ???
The pots are 5K, I don't know of any drawings.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 9xr gimbal resistance ???
Hi Mike and thanks for the info. I presume that all 4 gimbal pots are 5K.
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: 9xr gimbal resistance ???
Hi tolisn,
I believe the 9XR and 9XR PRO use similar pots as the 9x Radios.
The Mode 2 / Gimbal Throttle pot is the same but the other three Gimbal Pots have different values.
For some info and dimensions see: (viewtopic.php?f=95&t=2974).
Also see info for 9XR Gimbal Pots here: (viewtopic.php?f=95&t=2974&start=150#p54150).
Bob B.
I believe the 9XR and 9XR PRO use similar pots as the 9x Radios.
The Mode 2 / Gimbal Throttle pot is the same but the other three Gimbal Pots have different values.
For some info and dimensions see: (viewtopic.php?f=95&t=2974).
Also see info for 9XR Gimbal Pots here: (viewtopic.php?f=95&t=2974&start=150#p54150).
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).