openrcforums

Hi again, I managed to set up the radio thanks to jhsa and Romolo.

I prepared the 9x for my little P47 Thunderbolt and it was fine until a bush appeared in my way and the little bird crashed against the ground



But now it's fixed and ready for another crash !!!

I've followed ht einstructions you give on the other post but now I have nother questions, after reading the manual I can't find how to setup a switch to do the following action....:

I want to program a switch to move the Elevator and the Ailerons at the same time in order to get fast clib/loops. I guess it should be using the mix but I can't imagine how....

Thanks for your help

So you want your ailerons to move up and down with elevator movement? You need to add a mix to your aileron channels: Change the 25% to suit how much movement that you want, and the switch to whatever switch you want to use.
-Gohst

Yeah, bushes, trees and lamps posts have the bad habit of moving and placing themselves in front of our models

Yeah, I took a look before the take off and was clear but sudenly a bush was in the middle !!!!

It's the price i have to pay 'cause I'm a newbie

Thanks for the imputs, I've check the instructions of gohsthb and works like a charm !!! Now it's time to check it on the fly field....hope not to get another bush in the middle again ....

Good winds and....happy fly