Turnigy Firmware
Turnigy Firmware
Does anyone have the New Turnigy firmware version 2? I have tried the firmware that is posted here but it does not work. I just get the blank screaming meanie.
I am using the smartie board to program with.
Any help would be greatly appreciated.
I am using the smartie board to program with.
Any help would be greatly appreciated.
Re: Turnigy Firmware
To reload the stock firmware you need both the flash and eeprom files. Did you load both?
-Gohst
Sent from my LG-P999 using Tapatalk 2
-Gohst
Sent from my LG-P999 using Tapatalk 2
Re: Turnigy Firmware
Yes I did, they are both in the zip file. I also did it in the order specified. Flash first then eeprom. I either get a blank screen or the screaming one.
Re: Turnigy Firmware
Which version of the SP board do you have? If you have Rev 2.2 or later, you need to have the radio powered on for flashing, if you have an older one power should be off.
Re: Turnigy Firmware
I have version 2 board. I just got it from HobbyKing. I also saw was two different downloads for the stockfirmware got both of them too no luck yet.
Re: Turnigy Firmware
Kilrah asked which version of the smartieparts board you have.
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Re: Turnigy Firmware
The smartiboard is a soderless board REV 2.3
Re: Turnigy Firmware
OK, then make sure you have the radio powered on when flashing.
Re: Turnigy Firmware
Yes it is powered on. I either get the eeprom error or just a blank screen. It will flash everything correct but the original firmware.
Re: Turnigy Firmware
Do you have any errors when flashing?
Re: Turnigy Firmware
No errors it acts like everything is ok.
When I try to open eprom file in eepe it says invalid binary EEprom file?
When I try to open eprom file in eepe it says invalid binary EEprom file?
Re: Turnigy Firmware
This is normal, eepe can't read the format of the stock firmware's eeprom, only the one from er9x.
Re: Turnigy Firmware
Figured it out. I am new to this stuff. I just flashed the eeprom using flash EEPROM to TX first, then used Write Flash Memory for the hex. All is back to normal.
Thanks for the input hope this helps someone.
Thanks for the input hope this helps someone.