Hi
This is my first post here and really hope that someone can help me.
I have just installed erx9 in my turnigy 9x and calibrated against my dji naza fc. All works ok. Now i like to now how i can mix in the gear switch to take over the 3 pos switch?
I have gps to my naza so the 3 pos switch is my flight control switch. And i really like to have the gear switch to failsafe. Hope you understand what i mean. Not so god writing in english.
Fredde
Erx9 with Naza multirotor controller
Re: Erx9 with Naza multirotor controller
On your CH5, add one more line below the mode select switches, and set it to XX% HALF, switch GEA, Multpx=Replace. The percentage of course being set so that the channel ends up in one of the "Failsafe" zones when viewing it in the Naza assistant.
Re: Erx9 with Naza multirotor controller
Thx kilrah
Problem solved!! Great help.
I have allso connected my lrs rangelink to my 9x.
Everything works now in naza gui but should i do some more in the erx9?
Thx again Fredde
Problem solved!! Great help.
I have allso connected my lrs rangelink to my 9x.
Everything works now in naza gui but should i do some more in the erx9?
Thx again Fredde
Re: Erx9 with Naza multirotor controller
No, shouldn't need anything else if you've configured the basic stuff (TX battery voltage alarm, calibrated sticks etc).
You CAN do a lot more, but that of course depends on what you want to do with your naza. Course/Home lock, gimba lcontrol, remote gain adjustment,...
I could show you my settings for my F550, but you'd probably run away very fast
You CAN do a lot more, but that of course depends on what you want to do with your naza. Course/Home lock, gimba lcontrol, remote gain adjustment,...
I could show you my settings for my F550, but you'd probably run away very fast
Re: Erx9 with Naza multirotor controller
Show me Just plan to use this things that i programmed for know. Son just ad a camera shutter. Gimbal control i managed to fix
Re: Erx9 with Naza multirotor controller
Hello
Have you seen this thread?
http://www.rcgroups.com/forums/showpost ... stcount=22
I hope it can help.
Have you seen this thread?
http://www.rcgroups.com/forums/showpost ... stcount=22
I hope it can help.
Re: Erx9 with Naza multirotor controller
Woops, had missed that post. See attachment. It's an open9x file, so you need to open it with companion9x.Tokaz wrote:Show me
- Attachments
-
- F550.zip
- (708 Bytes) Downloaded 390 times
Re: Erx9 with Naza multirotor controller
awsome and thanks found this post while trying to get my failsafe set
result 100% set up hex now with open9x and naza controller
now just waiting for a less windy day
Aitch
result 100% set up hex now with open9x and naza controller
now just waiting for a less windy day
Aitch