Hi
I have taranis x9, with Opentx 2.0.19
I have 2 FLVSS daisy chained, one has ID5 and other has ID7.
In Freelink you can assign also application ID, I set both to corresponding ID address.
Well I had it worked at one time on and off it was.............., but most of the time it only reads out 1, mine only reads out FLVSS with ID5
It confusing me a lot that it is not working.
I have no clue how to solve this issue
Regards Hans
Multiple FrSky FLVSS LiPo Voltage Sensor
- timmybeetle
- Posts: 14
- Joined: Wed Jul 01, 2020 12:35 pm
- Country: Netherlands
Re: Multiple FrSky FLVSS LiPo Voltage Sensor
You must only change physical ID, not application ID, that must stay default.
- timmybeetle
- Posts: 14
- Joined: Wed Jul 01, 2020 12:35 pm
- Country: Netherlands
Re: Multiple FrSky FLVSS LiPo Voltage Sensor
Hi
Thanks for rely.
But at first I had application ID both at 0, and it didn't work also.
So....I tried several options but no results sadly.
Regards Hans
Thanks for rely.
But at first I had application ID both at 0, and it didn't work also.
So....I tried several options but no results sadly.
Regards Hans
Re: Multiple FrSky FLVSS LiPo Voltage Sensor
The default application ID for an FLVSS is 0x0300.
- timmybeetle
- Posts: 14
- Joined: Wed Jul 01, 2020 12:35 pm
- Country: Netherlands
Re: Multiple FrSky FLVSS LiPo Voltage Sensor
Hello
Strange, I use Freelink and if I click on application ID it says default is 0....
Still not making sense to me.
regards Hans
Update
I used freelink to set for both FLVSS application ID to "0"
Same result only 5 cells are visible from my 10 cells setup?????
Shoot me....
regards Hans
Strange, I use Freelink and if I click on application ID it says default is 0....
Still not making sense to me.
regards Hans
Update
I used freelink to set for both FLVSS application ID to "0"
Same result only 5 cells are visible from my 10 cells setup?????
Shoot me....
regards Hans