I'm using stock firmware v2.
I want to control my rudder during hover using the PIT TRIM pot (AUX 2). I first assign PIT TRIM to ch7. Then I setup a mix with AUX2 being my master and the rudder being my slave. My offset is 0 and my up/down rates are at 100. When checking my DISPLAY I am indeed controlling AUX2 with my PIT TRIM pot, but I'm not getting any rudder output.
I've tried all AUX channels at no avail. I just can't seem to get a AUX channel mixed into my rudder. What am I missing?
Mixing AUX to Rudder
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Mixing AUX to Rudder
You are not running er9x or similar
I tried the stock firmware.. Could not get anything to work ; best bet. Upgrade!
Sent from my iPhone using Tapatalk
I tried the stock firmware.. Could not get anything to work ; best bet. Upgrade!
Sent from my iPhone using Tapatalk
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!