I have recently purchased a Q X7 Access radio (EU LBT) and a TinyHawk S
Obviously the TinyHawk S runs on D8 Mode.
I have followed a tutorial to upgrade firmware and deselect the (EU) setting which should re-enable D8 Mode.
This didnt work, and on further reading it turns out that maybe the access locks out the D8 Mode???
Is there any way i can downgrade the firmware, or has anyone had any luck binding this radio with the Tinyhawk s?
Thanks
Taranis X7 Access Using D8
Re: Taranis X7 Access Using D8
ACCESS radios don't have D8 anymore. Need an external module.
Re: Taranis X7 Access Using D8
Thanks. I was afraid that was going to be the case.
Would this module work to give me D8 compatibility?
https://www.t9hobbysport.com/frsky-djt- ... gKEHfD_BwE
If not can you point me in the right direction
Would this module work to give me D8 compatibility?
https://www.t9hobbysport.com/frsky-djt- ... gKEHfD_BwE
If not can you point me in the right direction
Re: Taranis X7 Access Using D8
It would yes, but without telemetry. You probably want the XJT instead since that allows telemetry, failsafe setting from the radio etc.