Item needed, Mean Well PSU: (https://www.th3dstudio.com/product/cr-1 ... mean-well/)
Upgrading the Stock Power Supply to the Mean Well PSU in a CR10 3D Printer.
The Stock CR10 Power Supply has been known to catch on fire
and the 12 volt output is very noisy.
So because some prints can be 50 hours of printing time and up,
which much of the time may be unattended becomes a safety issues.
The Mean Well PSU reduces the issues with EZABL and other bed leveling kits due to power ripple
and grounding and is a lot more reliability than the stock CR10 PSU.
UL Certified
VERY low Ripple
High Reliability
Direct Replacement for the stock PSU
350W Power Output
Mean Well PSU: (https://www.th3dstudio.com/product/cr-1 ... mean-well/)
Upgrade Stock Power Supply to TH3D Mean Well PSU (CR10 3D Printer)
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Upgrade Stock Power Supply to TH3D Mean Well PSU (CR10 3D Printer)
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).