openrcforums

Hello! I have recently upgraded my Horus X10S to 2.3.10 and I have the 4-in-1 multiprotocol module. When I bind a receiver using the multiprotocol module, it defaults to RX Number 00. In the past, if I assigned a receiver number to a model that was being used in another model it would warn me, but t...

I recently upgraded from a QX7 (Opentx 2.3.9) to a Horus X10S (Opentx 2.3.9). I want to set up a buddy box with the Taranis as slave and the Horus as master. I plugged a cable into each trainer port and set the Taranis to a default model with the "trainer" option set to "Slave/Jack&qu...

Kilrah wrote: ↑Tue Jul 28, 2020 2:32 pm And do you have the radio in bootloader mode?

Yep! I should mention that I've configured with Companion many times but haven't encountered this issue until recently.

Then I guess your radio profile must be set wrong (I'm assuming "load the models from my radio" is actually read model and settings from radio ?) The "Radio Type" field is set to "FrSky Taranis X7 / X7S". When I click "Read Models and Settings from Radio" the...

3djc wrote: ↑Sat Jul 25, 2020 6:33 am You don't even mention your radio type ....

My apologies. I have a Taranis QX7.

I recently updated to OpenTx Companion 2.2.4 (with new firmware on my Taranis QX7) and everything worked great. However, it's been a few weeks and now when I go to load the models from my radio I get the error "Can't extract RADIO/radio.bin" I've tried restarting the radio and restarting c...

Hello! I have a Taranis QX7 with the 4-in-1 multi-protocol module. In the setup screen I can select between receivers 0-15, but not past 15. I have more than 16 receivers I would like to bind to my radio. Why is this limitation here, and can I get around it?