er9x Range Check

[taz85268]

Hi All,

There is a really good You Tube video (http://www.youtube.com/watch?v=_g6v__Lrvyo) of a different way to do a Range Check on a Turnigy 9x Transmitter causing Channel 1 to oscillate back and forth from +95% to -95% but uses open9x.

Does anyone know how to create a template of Channel one that Oscillates back and forth using the er9x firmware?

I have tried getting this example to work in er9x but er9x doesn't seem to allow a Channel to be assigned to a custom switch.

Thanks,
Terry

[Kilrah]

ER9X, like openTx, has a Servo Test template on the templates page. Just apply that to a new model.

[MikeB]

On er9x, you set the mix source to FULL and then set the mix switch to the custom switch. When the switch is OFF, the mix will be -100% and when ON the mix will be +100%.

Mike.

[taz85268]

MikeB...

Thanks...
That was the trick to get it working...
Now... For a drive to see what the range of my new FrSky DHT/D8R-XP system is.

Dang, I love these forums!!!

[lancaster]

thanks Mike
great tip
it seems a simpler template than the one supplied with ER9X
regards
Hans