Hello Everyone,
I recently performed a chip replacement on a Taranis X9D+. I also replaced both R76 and R77 with 12K (R76) and 2K4 (R77) like described in this post: https://openrcforums.com/forum/viewtopic.php?t=10031 . I now have 4.8V on R77 when plugged in via USB, no stm bootloader starting and nothing happening besides a quiet buzzing from the speaker. I am wondering if the resistor values are the same with plus and non plus version.
Taranis X9D+ non 2019 Voltage on R76 4.8V Radio not starting only buzz from Speaker
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Taranis X9D+ non 2019 Voltage on R76 4.8V Radio not starting only buzz from Speaker
X9D+:
R76 30.9K 1%
R77 10.0K 1%
X9D (rev 0.4):
R76 29.4K 1%
R77 10.0K 1%
An earlier circuit diagram for the X9D showed R76 as 12K 1% and R77 as 2K4 1%.
Mike
R76 30.9K 1%
R77 10.0K 1%
X9D (rev 0.4):
R76 29.4K 1%
R77 10.0K 1%
An earlier circuit diagram for the X9D showed R76 as 12K 1% and R77 as 2K4 1%.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Taranis X9D+ non 2019 Voltage on R76 4.8V Radio not starting only buzz from Speaker
I replaced the two resistors and now the radio works perfectly! Thank you very much mike.
Refuhr
Refuhr