FS-GR3E issue - Throttle full when radio is booting

[biomecanoid]

Hello,

The model in question is a Remo Smax and i used the following parts:

Motor
https://www.ebay.com/itm/Surpass-2845-4 ... 2749.l2649

Robinson Reducer Sleeve 5mm-1/8"
https://www.ebay.com/itm/323582654809

Receiver:
https://www.ebay.com/itm/Flysky-FS-GR3E ... Swgv5ZeFl3


The car feels fast and powerful but i think i am having an issue with the Flysky-FS-GR3E:

If i leave the car running and turn off the iRangeX Transmitter the car stops which means i have setup successfully the failsafe but when i turn on the transmitter for the few 1-2 seconds that the transmitter boots its firmware the car turns on throttle full blast and stops when the transmitter is finished booting, whats up with that ?? i have lots of models with an FS-GR3E receiver and never had an issue.

The way i set the failsafe is by pressing the button on the receiver. Very weird issue. My receiver is afhds and the failsafe is set only from the receiver. The only failsafe settings i have on the transmitter is for afhds2

Could the problem be the IRangeX controller ? Its the receiver malfunctioning ? did i program that behavior by mistake ? any ideas are welcome

Thank you
Chris

[biomecanoid]

Hello,

Nobody can help ??

Thank you
Chris