I have an X4R 4Ch module (the one without sbus).
Is it possible to flash this and get sbus?
It looks like there are only 2 firmwares available, EU and non-EU?
Pictures of the two versions
X4r 4Ch flash to s-port
Re: X4r 4Ch flash to s-port
They both run the same firmware, the difference is done in hardware by the placement of a 0-Ohm resistor on the board (the connector pin for CH4 either connects to the SBUS signal or the CH4 one). If you're able to solder very small things you can change it.