Hi all,
I am new at oXs and about to learn how to handle all that stuff.
My first project is a 4S LiPo sensor for my FrSky system.
First steps worked well unti I destroyed my test arduino mini pro.
Expected a bunch of more arduinos in my scratch box, I had to learn, there are only arduino micros (leonardo type)
So far ... so goog ... not a problem at all.
But while compiling I got an error message which turns out something is not declared.
I did not understand everything but it seems a timer is missing on this creepy board?
The message output is attached to this post.
Does anybody know what to do?
Thanks a lot
Cappy
error message while compiling for arduino mikro (leonardo)
Moderator: rainer
error message while compiling for arduino mikro (leonardo)
- Attachments
-
- Fehler_arduino_micro.txt
- (4.51 KiB) Downloaded 244 times
Re: error message while compiling for arduino mikro (leonardo)
oXs needs an AVR328p processor. It is used on Uno, nano, pro mini but not on leonardo.
Re: error message while compiling for arduino mikro (leonardo)
I'm willing to give this a try... the compile errors are not that hard to correct. PCIF2 & PCIE2 should be replaced with PCIF0 en PCIE0 for the atmega32u4. If you want to debug you need to replace HardwareSerial with Stream...
I got to the point that i see some voltage readings in the serial monitor. Next i'm going to put together a real hardware setup with a frsky X receiver and see if it really works
I got to the point that i see some voltage readings in the serial monitor. Next i'm going to put together a real hardware setup with a frsky X receiver and see if it really works