Firsrt... I'm a nube to Opentx, Jumper transmitters and Lemon Stabilizer receivers however I believe opentx may solve my problem. My rudder and ailerons are not responding as expected.
After setting the model on the Jumper with multi dsm subtype x 11ms I bound the lemon receiver with the Jumper Xmitter. Everything ok.
Next the switches 4&5 were flipped on the lemon to indicate a normal 4 channel setup.
Powered it all up and at first everything seem fine. BUT when I checked the channel assignments there was a problem. The rudder moved when the ailerons should have ...meaning when I mover the right hand controller left and right the rudder moved. The opposite occurred when I moved the left controller.
I hopped to correct the problem by switching the servo connections, and it did however ... now the auto correction for the stabilizer is now incorrect.
I'm hopping I can switch connect the rervos normally and make a change on the Jumper transmitter. Can transmitter channels be reassigned?
Any help will be appreciated
Thanks BobV