On my output page I had to change the the min/max of all of my channels to match my flight controller extremes. But now my channel log shows something like -83% when I’m in brittle hold. I want the channel output in this case to be expressed as -100%, even though I decreased (increased?) the min value.
Is there a way to do this? I really like the channel monitor but I want it to obey the modified extremes of my outputs, not look at the default extremes.
X10S with OpenTX 2.2.3
Want output to read 100% even though I modified min/max
Want output to read 100% even though I modified min/max
Last edited by xoexoe on Wed Jul 03, 2019 12:16 am, edited 1 time in total.
Re: Want output to read 100% even though I modified min/max
No, the monitor and log are about the exact value sent out.
You can look at the top bar on the monitor to see what goes into the "outputs" stage.
You can look at the top bar on the monitor to see what goes into the "outputs" stage.