Model select menu requires reboot?

[hnygaard]

Hi

First of all, thanks to the developers! I really like the initiative.

I just flashed my new radio with er9x (plain r762, no additional options, d/l from googlecode) - and it looks really good. However, I cannot open the 'Model Select menu' if I have opened 'Radio Settings' - unless I reboot the radio - is this intentional, or is something the matter?

Steps to reproduce:
1. Turn on radio
2. Open 'Radio setup' with [left long]
3. Exit with [Exit] - duh..
4. Trying to open 'Model Select' with either [Menu long] or [left right] results in 'Radio settings' opening.

Powercycle and 'Model select' opens fine.. If 'Radio settings' has not been opened since turning the radio on, 'Model select' opens fine.

Any advise is much appreciated.

BR
/Hjalte

[Crucial]

Model settings is usually opened with a long right if I remember right

[jhsa]

That is correct..

[MikeB]

MENU LONG takes you back to the last menu you were in, it defaults to the model select screen at power on.
As stated above, RIGHT LONG takes you to the model select screen.

Mike.

[hnygaard]

There you have it, that did the trick. Confused me that one button too me two different places, but with the 'previous menu' it makes sense.
Thanks guys