openrcforums

Hi all,

Very New to the Taranis. I have been able to setup a basic model, gone through all the tutorials I can, but am stuck on setting up the choke on SF.

Can anyone Pleeeaaassseee point me to a walkthrough that will give full travel of a servo on a switch. I have been able to get half of the travel one way but can't figure out how to get the servo monitor to show travel both on SF(Up arrow) and SF(down arrow)

Thanks in advance,
Dan

Just set the source of the mix to SF?

Mike.

MikeB wrote:Just set the source of the mix to SF?

Mike.

Thankyou. I had the source set as SF but also had a switch defined. Once I put the switch to ---, all works.

Thanks!!!