Analog input problem after m128 upgrade
Posted: Wed Dec 23, 2015 7:50 am
Hi, I recently upgraded my turnigy 9x with m128 (Atmega128a) and I'm getting this strange problem that both the a1 and a3 values are being controlled by the pitch stick, whereas my yaw stick doesn't have any control. I have checked every point with a continuity tester and there are no solder bridges. I have selected 9x/m128 fw. I hope I have the fuses right, I found them on some russian site. Also I get verification error when I try to burn the fw:
Can anyone help? Thanks
Code: Select all
Writing | ################################################## | 100% 105.05s
avrdude.exe: 66790 bytes of flash written
avrdude.exe: verifying flash memory against D:\Program Files (x86)\OpenTX\FW\opentx-9x128-frsky-heli-templates-nosplash-gvars-autosource-autoswitch-dblkeys-battgraph-thrtrace-pgbar-sqt5font-en-2.1.6.hex:
avrdude.exe: load data flash data from input file D:\Program Files (x86)\OpenTX\FW\opentx-9x128-frsky-heli-templates-nosplash-gvars-autosource-autoswitch-dblkeys-battgraph-thrtrace-pgbar-sqt5font-en-2.1.6.hex:
avrdude.exe: input file D:\Program Files (x86)\OpenTX\FW\opentx-9x128-frsky-heli-templates-nosplash-gvars-autosource-autoswitch-dblkeys-battgraph-thrtrace-pgbar-sqt5font-en-2.1.6.hex auto detected as Intel Hex
avrdude.exe: input file D:\Program Files (x86)\OpenTX\FW\opentx-9x128-frsky-heli-templates-nosplash-gvars-autosource-autoswitch-dblkeys-battgraph-thrtrace-pgbar-sqt5font-en-2.1.6.hex contains 66790 bytes
avrdude.exe: reading on-chip flash data:
Reading | ################################################## | 100% 59.74s
avrdude.exe: verifying ...
avrdude.exe: verification error, first mismatch at byte 0x10000
0x0c != 0x70
avrdude.exe: verification error; content mismatch