Page 1 of 1
Switch RF Module automatic when select another protocoll ?
Posted: Tue Apr 24, 2012 7:51 pm
by Kayle
Hello,
i look at the schematic of the 9x and find out, that the PC0 pin is also unused. I have FrSky and Spektrum in my transmitter. At the moment i use a "hardware" switch to switch between the two RF Modules. Is it possible to get following:
Model 1 select ( Protocoll PPM ) -> PC0 = 0
Model 2 select ( Protocoll DSM ) -> PC1 = 1
???
Best Regards
Kayle
Re: Switch RF Module automatic when select another protocoll
Posted: Tue Apr 24, 2012 8:46 pm
by cre8tiveleo
You can use both, pump channel x to ppm x.
At least that's what I understand from what is in the new firmwares.
Re: Switch RF Module automatic when select another protocoll
Posted: Tue Apr 24, 2012 9:26 pm
by Kayle
You can use both, pump channel x to ppm x.
At least that's what I understand from what is in the new firmwares.
Sorry, but i don´t understand.
Does the PC0 ( free Pin on Atmega ) already change, when i switch to another protocoll ?
Kayle
Re: Switch RF Module automatic when select another protocoll
Posted: Tue Apr 24, 2012 10:20 pm
by cre8tiveleo
no pc0 doesn't already change... might need more beer... it's all good
Re: Switch RF Module automatic when select another protocoll
Posted: Tue Apr 24, 2012 10:42 pm
by Kayle
year beer is good ... sometimes
Ok, i will have a look to get the pc0 pin working.
Kayle
Re: Switch RF Module automatic when select another protocoll
Posted: Fri Jun 15, 2012 10:43 am
by Kiro
Any news here ?
Re: Switch RF Module automatic when select another protocoll
Posted: Fri Jun 15, 2012 5:24 pm
by jhsa
I don't think that is a good idea, but there's a spare output on the voice mod board that could be used for something like this? I still think that is too dangerous though..