The only change I made was to save some eeprom space. I removed a duplicate pitch curve for ID2. ID1's curve is the same. This also allowed one mixer line to be removed as well.Here you go I use this for my BeastX & CX-3X1000 FBL units
-Gohst
The only change I made was to save some eeprom space. I removed a duplicate pitch curve for ID2. ID1's curve is the same. This also allowed one mixer line to be removed as well.Here you go I use this for my BeastX & CX-3X1000 FBL units
do we need to assign 'collective' in heli setup parameter? or just leave it blankgohsthb wrote:from kgd1 on RcGroups,The only change I made was to save some eeprom space. I removed a duplicate pitch curve for ID2. ID1's curve is the same. This also allowed one mixer line to be removed as well.Here you go I use this for my BeastX & CX-3X1000 FBL units
-Gohst
okay..will get back once i manage to setup my heli..Kilrah wrote:No, do not use the heli setup page with any FBL controller.