openrcforums

My problem is that my camera does not move smoothly, especially when i use my goggles it works even worse, when i use the knops its margantly better but not much
i am using an turnigy 9x with an xjt module and x8r module, i have bound it i 16 channel mode, and using pxx protocol, i have tried the other protocols aswell, but it wont work smooth, it is not the servos, because it does exactly the same with 2 others

http://youtu.be/B5mnKcGwlUY

Need more info. What's your entire setup and how are things connected? Servos direct on receiver?

yes servos is connected direct to the x8r module on channel 9 and 10 channel 11 is landing gear, the naza is connected to the sbus port on the x8r
and s.port is connected to a lipo monitor,

The x8r is powered via the naza and
so channel 1-8 goes to naza via sbus and 9-16 is the pysical pins on the x8r

it is all powered by dist board and an 6 s battery,

Move radio a bit further from receiver - if no difference it's just crappy servos. I remember similarly poor performance from that gimbal.

ok, but but it happens to other servos aswell, and i know they have worked before, just with a different setup on my old quad, but same reciver and and transmitter ill tray to if it helps with the radio further away


edit: it did not help with the radio further away