A2 Telemtry voltage slowy increases over time.
A2 Telemtry voltage slowy increases over time.
Hi guys. So ill start with my setup, rev 816 FRSKY on my 9x. I just installed a modded djt module following the non converter guide. The receiver is a D4R-II hooked up to my Naze32 telemetry port. A1, RSSI and altitude work great. But if I set the voltage(increase it till I get the proper voltage that matches my battery) and let it sit for idk maybe 15-30 seconds the displayed voltage slowly increases, I the go back and lower it till its correct..... Then it slowy starts increasing again. Then if I reset everything my displayed voltage is really low and slowly goes up. I can never get it to stay at the correct voltage. Anybody ever deal with this issue?
Re: A2 Telemtry voltage slowy increases over time.
Do you actually have something connected to the receiver's A2 port?
I guess not, and you're just looking at the wrong value.
The Naze returns the voltage it measures into the VFAS field (see documentation of the Naze firmware you're using).
I guess not, and you're just looking at the wrong value.
The Naze returns the voltage it measures into the VFAS field (see documentation of the Naze firmware you're using).
Re: A2 Telemtry voltage slowy increases over time.
Yah know what, im totally dumb today lol. VFAS works great, I dont know why I was trying A2. Thanks bud! Im using cleanflight and the telemetry documentation does not mention that.