openrcforums

I have my Turnigy 9x up to speed with the SmartieParts 2.4 board and the latest er9x flashware
Version:
SVN: er9x-r814
VERS: V1.394-Mike
DATE: 16.11.2014
TIME: 23:20:08

My transmitter is Mode 1 from factory. On the model screen, it shows:
Left side - THR
RUD
ELE
Right side - AIL
GEA
TRN
I would like to name them correctly. I have looked everywhere and cannot seem to find a solution
Any help from the gurus is good. I have been through the menus with no success and the er9x guide only states to change modes without any further explanation.

Those three names down each side are the switches, not the sticks. When a switch is turned ON, the switch name is highlighted.

Mike.

Thanks...Mike.
That was simple...I should have known that.