I have my Turnigy 9x up to speed with the SmartieParts 2.4 board and the latest er9x flashware
Version:
SVN: er9x-r814
VERS: V1.394-Mike
DATE: 16.11.2014
TIME: 23:20:08
My transmitter is Mode 1 from factory. On the model screen, it shows:
Left side - THR
RUD
ELE
Right side - AIL
GEA
TRN
I would like to name them correctly. I have looked everywhere and cannot seem to find a solution
Any help from the gurus is good. I have been through the menus with no success and the er9x guide only states to change modes without any further explanation.
Mode 1 stick assignment
- MikeB
- 9x Developer
- Posts: 17997
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Mode 1 stick assignment
Those three names down each side are the switches, not the sticks. When a switch is turned ON, the switch name is highlighted.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Mode 1 stick assignment
Thanks...Mike.
That was simple...I should have known that.
That was simple...I should have known that.