r213, 3pos switch missing

[cudaboy73]

I'm using a 9XRPRO with with the latest version r213, the 3pos switch is missing when I go to source in the edit menu in CH mixer can any one help plz.

[MikeB]

r213 allows ANY switch to be used as the mixer source. The name 3POS has been changed to SWCH. Beside this, is the name of the switch being used. When SWCH is highlighted, press MENU LONG, and the switch name beside it becomes highlighted. You may now choose the switch, the standard 3-position switch is named IDx.

Mike.

[cudaboy73]

Thanks Mike got it, One more thing, having problems getting my Rssi signal to work any help would be great, I'm using a FrSky D4R-2, I tried changed all the UsrProto + Met/Imp, still reading 0 Tx and 0 RX.

[jhsa]

If you have the DJT module and are using the telemetry cable that connects the module to the futaba trainer port, go to the telemetry 2 menu, scroll down to "frsky COM port, and select COM 2. I think it is 1 by default.

João

[cudaboy73]

I'm using a 9XR PRO with a XJT module

[MikeB]

Checking the basic settings: You should have PXX in D8 mode, the COM port should be COM1 and the COM1 invert should be OFF.

Mike.

[cudaboy73]

PXX is on D8 mode, I having trouble finding the com port

[jhsa]

If you have the DJT module and are using the telemetry cable that connects the module to the futaba trainer port, go to the telemetry 2 menu, scroll down to "frsky COM port, and select COM 2. I think it is 1 by default.

João

[cudaboy73]

Thanks guys, I'm in com1, invert is off, com2 function in on telemetry, I'm get 80-100 on RX and 1 on TX jhsa I tried on com2 same thing.

[cudaboy73]

Sorry jhsa, com2 nothing.

[jhsa]

If you have the XJT module, you need COM 1.

João

[cudaboy73]

RX is high but now I'm seen 30 max on the TX, on com 1

[MikeB]

OK, I think all is now. With the XJT module, the TX RSSI is replaced by a SWR reading that is usually 0 or 1.
Go to the TELEMETRY menu, and set a range value of 13.2 for A1. You should now see the receiver voltage displayed at the right of the screen.

Mike.

[cudaboy73]

Ok I set that range value at 13.2v for A1 now it shows A1 with 0.0 above the RX to the left. Tx is still at 30-35