FrSky Telemetry hack
Posted: Mon Apr 02, 2012 11:01 pm
Hi,
just a question, i wanted to prepare my flysky th9x for the FrSky module thats on the way. So i desoldered the resistors, soldered the cables to the pins on the top of the Atmega , 220ohm and go to the desoldered resistorspads (under this). Flashed the er9x_frsky_noht and see .. nothing happend when i switch throttle cut oder aileron d/r.... no reaction on both switched.... before i flashed the new fw i tested the switches with the normal er9x and there's happend nothing (after the mod) so that shoud be alright.
As far as i read, this mod is only there to free the inputs for the rx/tx telemetry data and put it on another input pins. That shouldt work without the frsky module too or not ? Ive done the error to put all the solders in hotglue (i thought im sure its right soldered, double checked it 5 times) so i have to remore it slowly without damgeing something.
Could it be that the switched dont react without the frsky module ? (some hope... Or must they react without the module ? (i think they must do it without the module)
Something more, with the standard er9x i got the switches error, and with the er9x_frsky.... i got no error message ....
Some hints for me whats wrong, or what to do next to get it run like expected ?
thanks forward
Ironstone
just a question, i wanted to prepare my flysky th9x for the FrSky module thats on the way. So i desoldered the resistors, soldered the cables to the pins on the top of the Atmega , 220ohm and go to the desoldered resistorspads (under this). Flashed the er9x_frsky_noht and see .. nothing happend when i switch throttle cut oder aileron d/r.... no reaction on both switched.... before i flashed the new fw i tested the switches with the normal er9x and there's happend nothing (after the mod) so that shoud be alright.
As far as i read, this mod is only there to free the inputs for the rx/tx telemetry data and put it on another input pins. That shouldt work without the frsky module too or not ? Ive done the error to put all the solders in hotglue (i thought im sure its right soldered, double checked it 5 times) so i have to remore it slowly without damgeing something.
Could it be that the switched dont react without the frsky module ? (some hope... Or must they react without the module ? (i think they must do it without the module)
Something more, with the standard er9x i got the switches error, and with the er9x_frsky.... i got no error message ....
Some hints for me whats wrong, or what to do next to get it run like expected ?
thanks forward
Ironstone