openrcforums

hi sorry to buggy you but i face a issue that i dont understood,

i have 9XR and a tbs disco

and what the setting i put mode 1, mode

the rigth stick on his horizontal axis make rotate the model,

it was working before i rebind the tx, i've seeked the naza soft and found nothing related,

i verified my cable from rx to naza test both possible connection, and that not solve the issue,

have you already faced that ?

thanks a lot,

f.

I may be totally off here ... but ... the hard setup of the transmitter (mode 1-4) should be matched by the selection made in the firmware otherwise you will get varying results.

Just changing the firmware setting does not change which stick is ratcheted.

You may have also changed the channel order. That will also through your settings for a loop.

It all works in a strange sort of harmony. When it is right, it is very right.

yes as i saw in a french forum, its seem in the mixer section,

so i've put :

CH1 : AIL
CH2 : ELE
CH3 : THU
CH4 : RUD