Turnigy 9x - Boscam HD19 setup
Posted: Sun May 11, 2014 3:36 pm
Hope this is in the right place . . my first post . I have a "stock" Turnigy 9x recently purchase from Hobby King. I have almost completed my carbon fibre stick built quad , , and it flies !!
I have a Boscam HD19 camera and I am trying to set up the remote stop start function of the video recording and single photo shot. I cannot use the 3 way switch because that is in use for the DJI Naza. I have found that I can control it by using one of the main stick controls - I used the channel 4 (rudder) in a test set up. On the "Display" on my 9x, when the rudder was in the middle no recording - when moved fully right, video started to record, back to the centre, video stopped, fully left and a single snapshot was taken. PERFECT !! But I don't know how to configure one of the knobs (preferably pit trim or hover pit) so it works the way of one of the four main stick channels - AND I need it on Channel 8.!!
I did manage of sorts, but could not get enough "range" on the black bars to get it to switch . . .
Hope someone can help me . . .
Hope someone can help
I have a Boscam HD19 camera and I am trying to set up the remote stop start function of the video recording and single photo shot. I cannot use the 3 way switch because that is in use for the DJI Naza. I have found that I can control it by using one of the main stick controls - I used the channel 4 (rudder) in a test set up. On the "Display" on my 9x, when the rudder was in the middle no recording - when moved fully right, video started to record, back to the centre, video stopped, fully left and a single snapshot was taken. PERFECT !! But I don't know how to configure one of the knobs (preferably pit trim or hover pit) so it works the way of one of the four main stick channels - AND I need it on Channel 8.!!
I did manage of sorts, but could not get enough "range" on the black bars to get it to switch . . .
Hope someone can help me . . .
Hope someone can help