GCL-2 On-board Glow Control Logic:
More info: http://www.rc-miskolc.emiter.hu/rc-misk ... Itemid=179
Put separate channel on receiver:
(Free receiver channel connected)
This time you need to program the right glowing upper and lower threshold on radio. Then enough put the threshold somewhere near the middle on GCL-2. The mixes, which on this channel of radio, will supply the right glowing functions (on/off, engine stop).
Sample glowing program under ER9X (for Turnigy 9X TX):
Implemented functions:
The throttle servo is placed on 3.ch, the glow is placed on 7 ch.n,
Main switch of glowing (disable/enable) : GEAR switch,
Motor cut switch: TRN switch.
The glowing is active, if the GEAR switch on and the throttle is on idling speed (The upper section of glowing is adjusted with GCL-2 „pos” trimmer.)
The glowing is OFF, when the motor cut is in use (for more successful stoping)
Mixes:
motor cut:
CH3 R -125 FULL TRN
Glowing:
CH7 100 CH3 GEA
R 100 FULL !GEA
SAFETY SWITCHES:
CH7 S TRN 100
On-board Glow control mix for GCL-2
On-board Glow control mix for GCL-2
http://rc.emiter.hu/ (MegaSound 9X, GCL-2, FrSky-RSSI-DAC, etc.) Keress fel!
Re: On-board Glow control mix for GCL-2
for ER9X
http://rc.emiter.hu/ (MegaSound 9X, GCL-2, FrSky-RSSI-DAC, etc.) Keress fel!
- ShowMaster
- Posts: 4327
- Joined: Thu Dec 29, 2011 3:44 am
- Country: -
- Location: Los Angeles, CA USA
Re: On-board Glow control mix for GCL-2
I needed a glow driver so I ordered one.
I like all the features.
I'm very pleased with my megasound boards quality.
A few questions.
I could use a mix mix for opentx and Taranis?
Board dimensions please.
Because of battery weight can it be modified for a 2 cell lipo?
For future repair or modifications is a schematic available to board owners?
Thank you
I like all the features.
I'm very pleased with my megasound boards quality.
A few questions.
I could use a mix mix for opentx and Taranis?
Board dimensions please.
Because of battery weight can it be modified for a 2 cell lipo?
For future repair or modifications is a schematic available to board owners?
Thank you
Re: On-board Glow control mix for GCL-2
Board dimension:
63mm × 42mm × 10mm
The basic operating functions without programming. Expand only worth the stop.
(without programing)
(Stop function with mix)
More info:
GCL-2 home page
Clients are available if needed in the schematic.
63mm × 42mm × 10mm
The basic operating functions without programming. Expand only worth the stop.
(without programing)
(Stop function with mix)
More info:
GCL-2 home page
Clients are available if needed in the schematic.
http://rc.emiter.hu/ (MegaSound 9X, GCL-2, FrSky-RSSI-DAC, etc.) Keress fel!