Hello,
I`m from Germany (so please sorry for my english) and it seems that nobody as the same problem as I have.
So here`s the setup:
Transmitter: 9x with shipped V2 Firmware from HK
AVR Programmer: Diamex (STK500V2)
Programming Software: eePe
and I tryed to flash er9x
The Problem:
After i wired my 9x i checked it again if it turns on. It did.
Than I turned it off and hooked up the Programmer. My PC (Windows 7) found it correctly.
In eePe I chose the Com Port and the Programmer type. And the M64 Processor type.
Than I flashed the Firmware. It read out the Firmware and I thought everything was fine untill he startet to write.
Befor it startet to write AVRdude said: write command failed. But eePe went on with writing.
After checking AVRdude said: contet mismatch.
The 9x doesent turn on any more
I tryed to flash it again and again. with slow data transfer and standard.
Everytime I get the same error.
The Picture is a screenshot from AVRdude.
Hope somebody can Help. To get me back smiling!
Thank you verry much!!
9X flash failed, bricked?
Re: 9X flash failed, bricked?
Does your programmer supply power to the target? If not the radio must be powered on.elbanano wrote: Than I turned it off and hooked up the Programmer. My PC (Windows 7) found it correctly.
Re: 9X flash failed, bricked?
Thank`s for the quick answer.
yes the programmer supplyes 5V.
yes the programmer supplyes 5V.