Recently received my Taranis coming from a Futaba FF9 and having problems with programing my Ellipse F3F glider..
I've been looking at the various templates but none of them are the same that I use and I'm having problems trying to convert them
I'd like crow brakes operated from the throttle, 3 flight modes switched from Switch E that drop the ailerons and flaps by about 2mm or raise by about 2mm and neutral position.
Also snap flap that can be switched in from Switch C
Its a Vee tail..
I'm on mode 1 if that makes any difference...
I'd appreciate any help as still I'm waiting for the Eureka moment as mentioned by Rob when everything falls into place...
Thanks
Help for F3F glider setup
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: Help for F3F glider setup
Have you started yet by working through the set up of a simple model, and understand how the mixer works?
Sent from my GT-I9300 using Tapatalk 2
Sent from my GT-I9300 using Tapatalk 2
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: Help for F3F glider setup
Have a look at the phoenix and speedo iix mixes on the templates.
They will help you get step one going.
Sent from my GT-I9300 using Tapatalk 2
They will help you get step one going.
Sent from my GT-I9300 using Tapatalk 2
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!