Hey guys, I need some help. Hopefully someone can. I just got a brand new 1500 mah Life 3s battery from HK. Fully charged it is 10.8V. My Tx is showing the wrong voltage though. The Tx says 10.3v, but when I check the battery with my voltage checker, it shows that the battery is 9.8.
Anyone have any idea how to fix this?
Thanks
Battery Calibration
Re: Battery Calibration
Z
BEWARE - WE ARE IN THE AIR!!!
What goes up... Should be controlled by a 9X!
BEWARE - WE ARE IN THE AIR!!!
What goes up... Should be controlled by a 9X!
- cre8tiveleo
- Posts: 1434
- Joined: Tue Dec 27, 2011 6:13 pm
- Country: -
- Location: Ontario,(GTA North)
- Contact:
Battery Calibration
On the analog menu (from the system menu)
You will see A8 , thats the battery.
Scroll down, and you can calibrate it to the proper voltage. (menu left/right)
You will see A8 , thats the battery.
Scroll down, and you can calibrate it to the proper voltage. (menu left/right)
Re: Battery Calibration
Thanks for the quick response guys
Re: Battery Calibration
Ok quick question again. Should I change it 10.8 v when the battery is fully charged? I just set it and when I loaded my eeprom into eepe, its not showing the correct voltage. When I try to change it in eepe, the most it will go up to is 9.9
- cre8tiveleo
- Posts: 1434
- Joined: Tue Dec 27, 2011 6:13 pm
- Country: -
- Location: Ontario,(GTA North)
- Contact:
Battery Calibration
Set it to the voltage of the battery, i use tx lipo battery, fully charged it's 11.9 volts, i set my alarm for 10v.
Whatever you measure it at, set it to that.
---
I am here: http://maps.google.com/maps?ll=44.003067,-79.457256
Whatever you measure it at, set it to that.
---
I am here: http://maps.google.com/maps?ll=44.003067,-79.457256