I'm trying to load openTx onto my Sky9 beta board (1st batch of 25) and I'm getting an error. I have been using ERSKY exclusively and have never had a problem updating the FW, in fact I just installed r163 the the other day. I was able in the past to install open9x with no issues.
I can read the EEPROM fine. I tried loading with and without the existing EEPROM backed up and writen back to the TX. I've tried with and without any options.
I have never had any problems reading or writing to this board. I can read and write ERSKY without any problems with C9 and eePsky.
Here are the screen shots.
Any ideas?
Can't burn openT
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: Can't burn openT
Yes, you don't have the latest zip from Romolo for the SAM-BA tool! I suppose that the zip you have is the first one that was not able to write over 128k. The bin from openTx with all options enable is bigger than ersky9x. That's why you have this error!
Re: Can't burn openT
Where would I find this zip file? Link?
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: Can't burn openT
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
Re: Can't burn openT
Rob and bertrand, thank you very much. Works fine now.
BTW Rob...your doing just a stellar job with the forum.
I'm glad I can upload pics now without having to monkey with them.
BTW Rob...your doing just a stellar job with the forum.
I'm glad I can upload pics now without having to monkey with them.