ER9X DR/Expo H/L Switch

[TechJunkieRC]

I am new to the Hobby so I hope this question has not been asked to death. I could not find a solution through the search.

When programming my DR/Expo and assigning SW1 and SW2 I currently have SW1 as Gear and SW2 as Gear for each surface so that I can go from L to H rates on all surfaces with one switch. My problem is that with the Gear switch forward I have High rates and I have to pull the switch back for Low rates. How do I reverse this? I have tried everything I can think of and I can go from Medium to High rates on Gear if I select !Gear for SW1 though it says M to the side. Maybe this doesn't actually matter and I am making more out of Low and High when they are just labels and what really matters are the actual values assigned to each. Just wanting to be sure I am doing it right.

[MikeB]

You are correct, they are just labels. There are three settings for expo/dual rates(H, M, L), set them to what you wish. 'L' rates can be larget then 'H' rates.
You should be able to use !GEA for both switches if needed.

Mike.