openrcforums

Thank you Mike, it is working great !!!
That did it

Only two of the tabs have squished up displays with the my display set to
"Custom DPI Setting" of 200%, and the two tabs are the Modes and Globals tabs.

The rest of the eepSkye5 test version July 16, 2019 tabs are looking very good.

Looking a little closer at these tabs, maybe could use some twerking,
but may they maybe good enough anyways.

The sub menu in Mixes may need to be looked at. Over all it is a big improvement, Thank you Mike !

Good, I've got something to work on to improve these other menus. Also, there is support in QT5 for other things that is missing in QT4.

Mike

I've posted a new version on the first post. Please test to see if the Modes menu scales now.

Mike

Will do ! Thank you.

Hi Mike,
Do not see any improvement in the Mode tab screen.
eepskye5.zip version 17-July-2019 12:41

I've just posted a new.exe file (just copy to your installation directory), see if this sorts the "Modes" tab please.

Mike

Yes, the Modes tab looks a lot better (eepSkye5 Test July 17_2019 17:38).

Another .exe only posted, please check the "Globals" tab and the mix dialog.

Mike

Also now looks fixed, Globals with sub Menu (eepSkye5 Test 17_July_2019_19:12).

Some other tabs with sub menu's -----------------------------------------------------------------------------------------
Simulating window, can expand it side to side, but not up and down.

I'll need to investigate how to sort those dialogs, and it may take a couple of days.

Mike

Thank you Mike, it is getting better all the time.

Hi,
Thanks Mike for your work.

found that nine point curves are presented and edited (stored ?) as five point. That is also true for the previous release.
Miguel

forgot to mention, the graphic shows "Editing curve 1", independent of the selected curve(s).

Miguel

They seem to be OK for me. Curves 1-8 are 5-point, 9-16 are 9-point, 17 and 18 are 9-point x-y, and curve 19 is 6-point.

Mike

Something is wrong on my side. (Win7 64 bits)

I have uninstalled eepe and eepesky, clean directory, reinstalled using er9x.com installation rev 422 feb 18,2018, (is this the latest stable release?) and the problem with the editing of curves is there. Those are shown as 9 point, but editing can only be done on curve 1.(5 points)
Miguel

It´s working now. And it was before.

I was trying to select curves on the tick box instead of the "Curve 10" box. My fault, sorry for the noise.

Miguel

Mike
[/quote]
I just installed eepeinstall, and eepe works, but eepesky starts with a UART screen, and nothing on the screen, works
scan, start, whatever

thus I cannot start the eepesky program, what is wrong here