openrcforums

Hi,

I have two radios, my original JR X-3810, with the Frsky telemetry module, the screen display that clamps to the handle, (forget the actual letters that name it)

And now I have my Flysky with the Frsky version of the ER9X firmware, and the Frsky telemetry hack module installed and working.

My question is now that I have bought the Frsky hub, the one that plugs into the Rx, into which you can plug all the Frsky sensors (which I also bought), can I display all that information in the Tx with the ER9X firmware ?

e.g. height, speed, position, climbing/sinking (for glider), motor / battery temperature, flight pack battery voltage etc.

I would also want to program various alarms on several of the telemetry values.

If this can be done, are there any guides out there showing me how to set it up ?

When you say you have done the telemetry hack module... Do you mean in of these mods?

http://openrcforums.com/wiki/index.php/ ... _telemetry

Rob

Yes, rewired the two pins off the the main chip, added all the resistors etc. I now get the extra frsky screens in setup, and I can see the screen with the black bars for RX and TX signal strength.

It's just I don't know what to do next, even as simple as programming an alarm if model starts to go out of range.

Ok... Have you flashed your radio now with either er9x-frsky or open9x-frsky versions?

If yes.. Which one?

On the telemetry1 setup screen, make sure UsrProto = FrHub.
All the values will then be available for display (custom display on page telemetry2) and as source for the custom switches.

I used this file: er9x-frsky.hex, I can't see how to get my Tx to display which version it is.

I checked the protocol, and it was already set to FrHub

It's where to go from here I am not clear on

What I want to do is set up the frsky voltage sensor to monitor flight battery, frsky temperature sensor to monitor motor temperature, and frsky vario sensor to monitor altitude in feet, and sink / climb

Right... If you where using open9x, I would be of more help.

In have not played with er9x in a while!

Not certain er9x has vario functions in it yet? Regardless there Re better people to answer the question on er9x that me

With open9x you would use custom functions. I believe er9x has a similar system.

Sent from my Nexus 7 using Tapatalk 2