openrcforums

Hello

I bought last week at HobbyKing following module for my Turnigy9x "FrSky DF 2.4Ghz Combo Pack for JR w/ Module & RX"
Link: -> http://www.hobbyking.com/hobbyking/stor ... le_RX.html



To bind the receiver and the controller go super

It occurs 2 problems

First The switch "THR CUT" and "AIL" do not work
Second The telemetry data is not displayed

What am I doing wrong?

You're using the frsky version of the firmware but haven't done the telemetry mod. Use the normal version.

Sent via mobile

I'm using firmware version FrSky Open9x for '9 X radios with Fr-Sky telemetry modification

The display is always "NO DATA"

Yes, if you want telemetry you have to do these modifications:
http://openrcforums.com/wiki/index.php/ ... _telemetry

If you don't do them, use the normal firmware (NOT FrSky).

Thank you for your reply

The modification with the 2 resistors is yes OK
But where do I have FrSky Rx and Tx FrSky solder.

The FR-SKY-DJH's all a cartridge




I still installed inside this board and a soldering is not possible otherwise get nothing around contact pins

CPU -> level converter (frsky upgrade lite as shown in the guide, or equivalent) -> RXD/TXD pins on the back of the module.