Now I'm in trouble.
This morning I updated c9x to to the latest release.
At the 1st attempt to burn a new fw into sky9x, c9x crashes. The new fw is loaded but the model memory/eeprom is reformatted.
I tried to load a old eepe file from the pc, tried to restore a model from the sd card. Both fails with "invalid" format.
Did I loose all my model settings?
regards
manu
c9x v1.03 r 1512 crashes while burning flash into sky9x
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: c9x v1.03 r 1512 crashes while burning flash into sky9x
Would you try the 1.04? I just fixed a bug there (for sky9x / gruvin9x / M128 boards).
Bertrand.
Bertrand.
Re: c9x v1.03 r 1512 crashes while burning flash into sky9x
My main problem is:
Is there a way to restore my model settings of a former fw release?
Is there a way to restore my model settings of a former fw release?
Re: c9x v1.03 r 1512 crashes while burning flash into sky9x
Yes, you should be able to open any previous bin/eepe file and then write it (not write from file, as eeprom format might have changed inbetween). BTW, ALWAYS do a manual backup before flashing. I also make one everytime I do some major changes to my model settings just in case.
BTW, for me 1.04 still fails on backup/restore with my m128 radio. If I load a correct eeprom on the radio, then reflash the same firmware with backup/restore enabled, c9x doesn't crash anymore but the radio says invalid eeprom. It's OK on stock board.
BTW, for me 1.04 still fails on backup/restore with my m128 radio. If I load a correct eeprom on the radio, then reflash the same firmware with backup/restore enabled, c9x doesn't crash anymore but the radio says invalid eeprom. It's OK on stock board.
Re: c9x v1.03 r 1512 crashes while burning flash into sky9x
I are right. Just that particular on I thought was my latest backup is corrupted, bad luck. Earlier ones are ok to load.
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: c9x v1.03 r 1512 crashes while burning flash into sky9x
1.05 now released. The problem should be fixed.
One stupid thing is that this last open9x version / sky9x board already does the conversions internally, if you didn't have checked the "backup" checkbox, there would not have been any problem
(hmm. correct english?)
Bertrand.
One stupid thing is that this last open9x version / sky9x board already does the conversions internally, if you didn't have checked the "backup" checkbox, there would not have been any problem
![Sad :(](./images/smilies/icon_e_sad.gif)
Bertrand.
Re: c9x v1.03 r 1512 crashes while burning flash into sky9x
c9x v1.05 still crashes when flashing eeprom with fw compatibility checked.
Re: c9x v1.03 r 1512 crashes while burning flash into sky9x
Telemetry A1 channel settings are zeroed when flashing eeprom into sky9x.