mixing for motor pod
mixing for motor pod
i have a hk ask 21m with extending motor pod...is it possable to do a mix that will cut the throttle untill the motor pod is fully extended using p2 ...but if p2 is moved from full it will cut the throttle ....thanks guys in advance
Re: mixing for motor pod
Yes, just use a custom switch to cut the throttle channel. Use v<ofs P2 90. The custom switch will become active whenever P2 is going low. Leaving a little room, 10 in this case, makes sure it doesn't activate sporadically if P2 has a little jitter at the end. Then use the custom switch on your throttle channel just like a throttle cut switch. R -100% HALF Switch(CS1)
-Gohst
-Gohst
Re: mixing for motor pod
thanks buddy .....just what i needed
Re: mixing for motor pod
works a treat ...thanks again