openrcforums

Hello everybody.
Here’s the way I’ve set my radio to fly my Notos DLG.
This is the way it works:
4 servos.MODE 1. Ch1 right AIL . Ch2 ELE . Ch4 RUD . Ch6 left AIL.
The normal mode fligh is with 3position switch on ID1
On ID0 I lift up ailerons of a couple of millimeters and low down elevator for speed.
On ID2 low down ailerons and lift up elevator for thermal
RUD switch is for launch mode, and when I push it back to off position, the timer starts.
On right stick(throttle, I’m using mode1) I have brakes, both ailerons down and elev up.
When the stick is on his low half position, rudder begins working.
On throttle cut I have ailerons-rudder mix, if I need it.
This is all,…I hope it works..and you like it.

I would think that for brakes you would be better off raising the ailerons. (spoilerons).

The reason for this is all about preventing a tip stall.

Guess it depends on the end model?

what you say it's what i do with my gliders on slope... but looking on youtube,i've seen that all dlg gliders low down ailerons. i don't know why(i'll ask next week at myfirst dlg meeting) and
i'll check the two ways.
does the .eepe files works Rob? it's the first time i load one on this forum....

Will test when I actually get on to a computer. Companion does not exist for Android yet

for iPhone neither....unfortunately! ))

All loads and runs ok

good! ... and i like Companion9x!... just have to find and load the last version firmware of ....er9x or open9x....???

You can download them direct from companion!




Sent from my iPhone using Tapatalk