Page 1 of 1
Futaba DM8 module with ER9X
Posted: Sun Sep 09, 2012 8:47 pm
by cjapka
Dear guys,
anybody succesfully tried to mount FUTABA DM8 Module into ER9X? After success with MLP4dsm, i want to try this full range module...
It seems very easily, but I am not sure, if 3 wires (+, - , signal) is enough to run it...
Thanks for your answer!
Ondrej
Re: Futaba DM8 module with ER9X
Posted: Sun Sep 09, 2012 10:01 pm
by Rob Thomson
Yes. That should work. Only issue is securing the box effectively!
Sent from my Nexus 7 using Tapatalk 2
Re: Futaba DM8 module with ER9X
Posted: Sun Sep 09, 2012 11:04 pm
by cre8tiveleo
Re: Futaba DM8 module with ER9X
Posted: Mon Sep 10, 2012 9:19 am
by cjapka
WOW!! this board seems perfect! Dont you know, if there is only Voltage stabiliser or other parts? Thanks!
Re: Futaba DM8 module with ER9X
Posted: Mon Sep 10, 2012 11:59 am
by cjapka
Seems perfect! but ---out of stock:( and no more sources of this product on market:(
Re: Futaba DM8 module with ER9X
Posted: Thu Sep 13, 2012 4:22 pm
by cjapka
In stooock! Hooorray!!
Re: Futaba DM8 module with ER9X
Posted: Sat Nov 17, 2012 10:03 pm
by Alekseygo
If to invert the 10th pin of the dm8 futaba microcontroller turns into dm9 JR!!! polarity of input PPM and an arrangement of channels changes. If the stok firmware - is better to use as dm8, then the sequence of channels is true and BNF work truly. if er9x, it is better to change contact and there will be 9 channels. Pin10 connect or not connect to GND.
