Found my USBasp V2.0 today in the mail. Still waiting for more parts required to modify the radio (10 pin male IDC header). The programmer looks exactly like this one:
As you can see there is a jumper labeled 5V 3.3V on it. I presume that since the 9x runs on 5V, the setting should be 5V. Correct?
Regards,
Jan
USBasp V2.0 voltage setting
- MostlyHarmless
- Posts: 19
- Joined: Wed Aug 22, 2012 3:26 pm
- Country: -
- Location: Willow Grove, Pennsylvania, USA
USBasp V2.0 voltage setting
Curiously enough, the only thing that went through the mind of the RC helicopter as it fell, was, "OH NO, NOT AGAIN."
Re: USBasp V2.0 voltage setting
Yes 5V is ok older USBasp have only 5V or 0V by one jumper
Odeslano pomoci Tapatalk, Samsung mobile
Odeslano pomoci Tapatalk, Samsung mobile
- MostlyHarmless
- Posts: 19
- Joined: Wed Aug 22, 2012 3:26 pm
- Country: -
- Location: Willow Grove, Pennsylvania, USA
Re: USBasp V2.0 voltage setting
Thank you.
Curiously enough, the only thing that went through the mind of the RC helicopter as it fell, was, "OH NO, NOT AGAIN."