Hi all,
Been looking around to see if there is a program within the 9XR Pro system to set up an exponential servo operation without plotting said curve in curves? ---- I want to try on the steering of a boat!
Thanks in advance
Exponential servo operation?
- stotty1111
- Posts: 233
- Joined: Mon Aug 11, 2014 5:56 pm
- Country: France
- Location: overlooking Douarnenez Bay Finistere
- MikeB
- 9x Developer
- Posts: 17995
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Exponential servo operation?
Two possibilities:
1. Set up EXPO on the rudder stick in the EXPO/D.RATE menu.
2. Set EXPO (positive only available) in a mix. You choose between a CURV(e), DIFF(erential), and EXPO, then set the amount of EXPO you required on that mix.
Mike
1. Set up EXPO on the rudder stick in the EXPO/D.RATE menu.
2. Set EXPO (positive only available) in a mix. You choose between a CURV(e), DIFF(erential), and EXPO, then set the amount of EXPO you required on that mix.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- stotty1111
- Posts: 233
- Joined: Mon Aug 11, 2014 5:56 pm
- Country: France
- Location: overlooking Douarnenez Bay Finistere
Re: Exponential servo operation?
Thanks for that Mike!
Looking like an interesting time next time I visit the club pond!
Cheers
Tony
Looking like an interesting time next time I visit the club pond!
Cheers
Tony