Channel Delay on X9D Plus SE???
Posted: Fri Nov 11, 2022 4:04 pm
Hello,
I am very new to Open TX and currently have a Taranis X9D Plus SE with the factory open TX firmware on it. What I am trying to do is precisely control the time it takes for the throttle to get from 0 to 100. I think FlySky has a similar feature called "channel delay".
Basically I want to punch the throttle stick to 100 and have it programmed to go from 0 to 100 over a chosen length of time. Currently I am manually "feathering" the throttle to achieve the desired result.
Is there a way to do this on this radio, and if so please dumb it down as much possible because I am very new to this firmware, transmitter, and just programming/mixing in general.
Any help is greatly appreciated!
I am very new to Open TX and currently have a Taranis X9D Plus SE with the factory open TX firmware on it. What I am trying to do is precisely control the time it takes for the throttle to get from 0 to 100. I think FlySky has a similar feature called "channel delay".
Basically I want to punch the throttle stick to 100 and have it programmed to go from 0 to 100 over a chosen length of time. Currently I am manually "feathering" the throttle to achieve the desired result.
Is there a way to do this on this radio, and if so please dumb it down as much possible because I am very new to this firmware, transmitter, and just programming/mixing in general.
Any help is greatly appreciated!