Hello Everyone, i hope that someone can help me overhere.....
I'm proud to say that i already built 5 Openx Sensor!
It's an outstanding working piece.
Let's go to the issue...
I fly helicopters, planes , gliders and rc boats, and have one in each one.
I never got used to use a stick radio in the rc boat, i prefer a pistol radio.
In oder to get telemetry, since i'm using a multiprotocol module in my futaba 3 PKS i acquired an Frsky FSD dash board.
I get vario data aand some other info provided by the receiver module!
The problem is that when i use mine edge tx i'm able to discover all the id of the sensors, but in the Frsky dashboard i only get some, but other ones are lacking.
I believe that the Frsky dash expect the correct id for displaying it correctly!
I can't see individual cell voltages neither GPS data...
From the manual :
Gps isn' working, but i don't know if it's because the update rate is 10Hz, and the dash only accept 1Hz... i will check!
Could you help me in the advanced and basic config file in order to get it working?
Was i naive expecting that the Frsky FSD could decode the data sent from the Open X sensor?
All works good with the Jumper T16..
Thank you in advance for all your help!
Best Regards
Openx Sensor + Frsky FSD
Moderator: rainer
Re: Openx Sensor + Frsky FSD
It's just that the FSD only supports what's on that list and that doesn't include cell voltage, GPS etc...