Jumper T12 3 Position switch wont work
Posted: Sat Jun 11, 2022 2:17 am
Good evening.
I have a new to me jumper t12. I loaded up the most recent open TX fw to the Jumper, and the most recent firmware to my ELRS stuff.
I have the beta flight PWM transmitter, and I need CH5 to switch my zohd kopilot between modes. However, when I move my 3 position switch, it only works in two positions. The switch should work as follows:
UP - RTH
MIDDLE - Manual
DOWN- Stabilized
However, both UP and MIDDLE it stays in RTH, and DOWN is Stabilized mode. It is completely skipping the middle mode. The screen reads 100, 0, -100 as I flip through the switch.
I configured my switch according to these directions.
https://oscarliang.com/setup-switch-opentx/
Additionally, I tried moving it to different switches, and all of them acted the same.
I found this thread, and found some options to try in there, but none of them worked for me.
viewtopic.php?t=10598
Any ideas?
I have a new to me jumper t12. I loaded up the most recent open TX fw to the Jumper, and the most recent firmware to my ELRS stuff.
I have the beta flight PWM transmitter, and I need CH5 to switch my zohd kopilot between modes. However, when I move my 3 position switch, it only works in two positions. The switch should work as follows:
UP - RTH
MIDDLE - Manual
DOWN- Stabilized
However, both UP and MIDDLE it stays in RTH, and DOWN is Stabilized mode. It is completely skipping the middle mode. The screen reads 100, 0, -100 as I flip through the switch.
I configured my switch according to these directions.
https://oscarliang.com/setup-switch-opentx/
Additionally, I tried moving it to different switches, and all of them acted the same.
I found this thread, and found some options to try in there, but none of them worked for me.
viewtopic.php?t=10598
Any ideas?