Turnigy 9X Sticks not functioning, receiver bound.
Posted: Wed May 05, 2021 4:24 pm
Hello,
I've finished flashing my Turnigy 9X with ER9X and eepe. I wanted to start setting up the software for the model but the sticks won't move the servos.
I know that the receiver and transmitter are bound, to know this, I manually offset on of the servos by pushing the rod. Then I connect the receiver to the battery. Receiver shows flashing light. I then turn on the transmitter while purposely pushing the throttle up in order to get the throttle warning.
Once both the receiver and transmitter are on, I lower the throttle. When the alarm message comes off because the throttle is down, the servos on the plane center, and the receiver light stops blinking, showing a solid red.
That should mean that the receiver is properly bound to the transmitter, but moving the sticks does not do anything on the plane. I also know that stick movement is being acknowledged because I can see them move on the screen.
The only other mod I have done is switching the momentary switch from the right hand side to the left hand side, but the controller was working fine with the stock firmware.
This is my turnigy 9X. Receiver is the one received with it.
Any help greatly appreciated.
Thanks.
Bab
I've finished flashing my Turnigy 9X with ER9X and eepe. I wanted to start setting up the software for the model but the sticks won't move the servos.
I know that the receiver and transmitter are bound, to know this, I manually offset on of the servos by pushing the rod. Then I connect the receiver to the battery. Receiver shows flashing light. I then turn on the transmitter while purposely pushing the throttle up in order to get the throttle warning.
Once both the receiver and transmitter are on, I lower the throttle. When the alarm message comes off because the throttle is down, the servos on the plane center, and the receiver light stops blinking, showing a solid red.
That should mean that the receiver is properly bound to the transmitter, but moving the sticks does not do anything on the plane. I also know that stick movement is being acknowledged because I can see them move on the screen.
The only other mod I have done is switching the momentary switch from the right hand side to the left hand side, but the controller was working fine with the stock firmware.
This is my turnigy 9X. Receiver is the one received with it.
Any help greatly appreciated.
Thanks.
Bab