openrcforums

Hi,

I have RadioLink T8FB and R8EF - TX and RX. And TX16S with R8EF or FRSKY S8R glider model. Is there any possibility to set this as wireless trainer mode? Or even wired trainer mode? - T8FB has round svideo. TX16S is using mono cable.
I tried svideo - mono cable. With no luck. I did not saw Calibration under Trainer in opentx. I also tried instructables.com wireless trainer. But I used R8EF. Connected to middle pins. R8EF set up to PPM or SBUS mode. No luck.
RadioLink has its own wireless trainer mode with svideo-three pins-ppm RX. I am not sure which pins are used. Could wired mode be voltage problem? Or Wired also need 3 wires?

Thank you
Jozef

Working with standard mono-mono cable. Or stereo-stereo cable + converter mono-4pin din. Only problem was tx16s. Connector must not be fully inserted. Just insert it a bit. I put some spacer to stereo connector, so connector is not fully buried to tx16s. Not perfect, but working.