Setup a throttle hold but adjustable?

[wolfie]

just replaced the Traxxas TQi in my Traxxas Scale Crawler...
it had a function where if you pressed a momentary contact switch, the throttle would hold where it was at the time,
but also be adjustable via a pot control.
Is this a possibility on the Taranis X9D+?
thanks for looking...

[MikeB]

Should be possible. The main thing you need is a couple of mixes on the throttle channel, e.g. for CH3:
CH3 +100% THR
R CH3 +100% CH3 switch(SA-) [A replace multiplex mix]

With switch SA not in the middle position, then the throttle works normally (first mix line). With SA in the middle position, the second mix line takes over and holds the throttle in the current position.

Mike